POLYMAX CRYSTAL HIGH TACK EXPRESS CARTRIDGE 300GR BISON

IDEAL FOR

• Welding: e.g. glass, stone, natural stone, concrete, structural plaster, many synthetic materials, wood, novopan, Trespa, iron, aluminum, zinc, steel, stainless steel and other metals, ceramic tiles, cork and mirrors.
• Connection: e.g. skirting boards, paneling, window sills, thresholds, roof cornices, structural boards, insulating materials, plasterboard, polystyrene trim and decorative frames.
• Sealing: e.g. skirting boards (synthetic), frames, steps, window sills, thresholds and false walls. It is also suitable for sealing cracks in walls and ceilings.

BEFORE USE

• Working conditions:Apply only at temperatures between +5°C and +40°C.
• Surface Requirements:Both parts must be dry, clean, free of dust and grease. No primer is required. The surface may be slightly damp.
• Tools:Use a silicone gun to handle the cartridge. If necessary, use a rubber mallet to lightly tap the surface.
• Product preparation:Before use, open the ampoule by cutting the plastic nipple at the top of the ampoule with a sharp knife. Screw on the nozzle and bevel to the desired diameter.

DURING USE

• Cartridge management:Welding and fixing: Cut the nose to a diameter of at least 0.5 cm. Sealing: Cut the spout at an angle according to the desired width of the joint.
• Instructions for use:Bonding and fixing: Apply in lines or dots (every 10 – 40 cm). Always apply in the corners and along the edges of the structural boards. Install the material properly within 10 minutes and press firmly or tap with a rubber mallet. If necessary, clamp or stabilize heavy materials for 4 hours. You can use the surfaces after 2 hours, at which point the connection will now be strong enough to withstand transport or a light load. The maximum final strength is reached after approximately 4 hours, depending on the surface (at least 1 porous material) and the ambient conditions. Sealing: Apply evenly to the underside of the joint and spread within 10 minutes using a putty knife, a silicone sanding tool or your finger after wetting them (with non-lemon soapy water). Work the vertical joints from the bottom up. Complete hardening is achieved after a few days (depending on the thickness of the layer). When painting with an alkyl paint, the paint may take longer to dry.
• Attention points:The following drying times are based on bonding at least one porous material with an adhesive layer approximately 1 mm thick. If you are joining two non-porous materials and/or the adhesive layer is thicker, drying times may be significantly longer. If the glue is applied underwater, it may turn white.

AFTER USE

• Stains / residues:Use turpentine to clean tools and remove fresh glue residue. Dried adhesive residues can only be removed by mechanical means.
• Storage conditions:Close the container tightly and store in a dry, cool place where there is no chance of ice forming.