FAST FIX LIQUIDMETAL 10 G BL BISON

• Very fast: about 60 sec.
• Extremely strong
• Filling capacity: up to 5 mm.
• Gel form
• Paintable and can be sanded
• Temperature resistant: from -40°/+80°C (for a short time up to +120°C)
• Water resistant
• No solvents
• Precise and clean application
• Transparent

Working conditions

Application temperature: between +5°C and +25°C.

Surface requirements

The surface must be dry, clean and free of dust and grease. Roughen surfaces with sandpaper (e.g. metals)

Preliminary surface treatment

The surface must be dry, clean and free of dust and grease. Roughen surfaces with sandpaper (e.g. metals)

Instructions for use

To assemble the double cartridge remove the black cap from the top of the cartridge and place the white plunger inside the syringe. To open the syringe turn (90°) the gray cap and insert the stirrer. Press the plunger and pour the first drops of glue. Apply a thin layer of glue to one side. Press lightly for about 30 seconds. When you finish the repair remove the stirrer and replace the gray cap to close the syringe so you can use the product again.

Advice

• When doing multiple jobs at once be careful to use the product so it doesn't mature in the blender about every 25 minutes. If it ripens, use a new mixer.
• Important: If you run out of stirrers you can do the mixing manually with the help of a wooden stick bearing in mind that the glue may not mix properly.

Stains / residues

Remove wet stains immediately with warm soapy water. Mature adhesive stains can only be removed mechanically.

Storage conditions

Store in a dry and cool place.