VINYL PLASTIC FOR SOFT FLEXIBLE PVC IN BLISTER BISON

Adhesive for repairing vinyl / soft PVC inflatables such as boats, pools, balls, mattresses, armrests, even waterproofs. Transparent, elastic, extremely resistant to UV radiation and water (marine). With repair kit inside the package.

Working conditions

Do not apply at temperatures below +10°C.

Surface requirements

The materials to be glued must be clean, dry and free of dust and grease.

Preliminary surface treatment

If necessary degrease with acetone.

Instructions for use

When gluing overlapping areas: Apply the glue in a thin layer over the entire surface of both materials to be joined. Allow to dry for 5-20 minutes. The glue should be dry to the touch. The drying time depends on the nature of the materials and the temperature. Combine the two parts and beat firmly. After joining the parts stick immediately! The final bond depends on the pressure applied to the materials so apply as much pressure as you can to the entire surface. If you are going to glue parts that will later be inflated (inflatable boats, life jackets, beach balls, etc.) let the joint dry for at least 6 hours before re-inflating them. When patching tears and holes: Use scissors to cut a piece of the patch enclosed in the package. The piece you will cut must be larger than the tear/hole you will be repairing. The larger the piece you cut, the better the weld you will achieve. Then follow the instructions for gluing in “overlapping areas”.

Advice

When you want to mend a tear, cut a small circle on both ends. In this way you will achieve the division of the intensity of the tear and prevent further extension of the damage.